| ipisoft.com https://forum.ipisoft.com/ |
|
| Does Ipisoft assume cameras are exactly vertical? https://forum.ipisoft.com/viewtopic.php?f=6&t=5161 |
Page 1 of 1 |
| Author: | jasonmcd [ Mon Jun 27, 2011 1:00 pm ] |
| Post subject: | Does Ipisoft assume cameras are exactly vertical? |
Hi Can anyone tell me if Ipisoft assume cameras are exactly vertical? I have 4 ps3 cameras recording, I noticed that one has a slight roll and wondered if this could be a factor in inaccurate calibrating or tracking? As a note, I am getting some good results, just need some tweaks here and there. |
|
| Author: | jasonmcd [ Tue Jun 28, 2011 6:28 am ] |
| Post subject: | Re: Does Ipisoft assume cameras are exactly vertical? |
I think I have the answer to my own question! I ran a calibration with one camera out of a set of 4 ps3 eyes, rolled 30 degrees and the calibration and then solved some mocap and it was successful, so I don't think it matters if the cameras are level or not. jasonmcd wrote: Hi
Can anyone tell me if Ipisoft assume cameras are exactly vertical? I have 4 ps3 cameras recording, I noticed that one has a slight roll and wondered if this could be a factor in inaccurate calibrating or tracking? As a note, I am getting some good results, just need some tweaks here and there. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|